2006-2011 Camry Aurion · Service Manual ENGINE

VC Output Circuit

Circuit diagnosis · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

The ECM constantly generates 5 V power from the battery voltages supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit.
A116143E15
When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied with power through the VC circuit are deactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.

HINT:
Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned to the ON position. The MIL goes off when the engine is started.


WIRING DIAGRAM

A132323E02

INSPECTION PROCEDURE


1. CHECK MIL CONDITION
  1. Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to the ON position.

    OK:
    MIL lights up.



NG
Go to step 2
OK

SYSTEM OK

2. CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the tester on.

  1. Check for communication between the tester and ECM.

    Result:
    Result
    Proceed to
    Communication is possible
    A
    Communication is not possible
    B



A
GO TO MIL CIRCUIT
B


3. CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the C5 throttle body connector.

  1. Turn the ignition switch to the ON position.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B

  1. Reconnect the throttle body connector.



A
REPLACE THROTTLE BODY ASSEMBLY
B


4. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR)
  1. Disconnect the A17 accelerator pedal position sensor connector.

  1. Turn the ignition switch to the ON position.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B

  1. Reconnect the accelerator pedal position sensor connector.



A
REPLACE ACCELERATOR PEDAL ASSEMBLY
B


5. CHECK HARNESS AND CONNECTOR
  1. Disconnect the C5 throttle body connector.

  1. Disconnect the A17 accelerator pedal position sensor connector.

  1. A107934E26
    Disconnect the A24 and C24 ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    VCTA (C24-67) - Body ground
    10 kΩ or higher
    VCPA (A24-57) - Body ground
    VCP2 (A24-58) - Body ground

  1. Reconnect the throttle body connector.

  1. Reconnect the accelerator pedal position sensor connector.

  1. Reconnect the ECM connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← ECM Power Source Circuit (from Jun 2009)VC Output Circuit (from Jun 2009) →