The ECM constantly generates 5 V power from the battery voltages supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit. When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied with power through the VC circuit are deactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.
HINT:
Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned to on (IG). The MIL goes off when the engine is started.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK MIL CONDITION
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch on (IG).