Security Indicator Light Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position.
Perform the ACTIVE TEST according to the display on the tester.
IMMOBILISER: Tester Display
Test Part
Control Range
Diagnostic Note
Security Indic
Turn security indicator
ON/OFF
-
- OK:
- The security indicator turns on and off according to the tester operation.
|
|
||||
| NG | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT) |
Disconnect the E15 ECU and F3 combination meter connectors.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E15-8 (IND) - F3-8 (LP)
Always
Below 1 Ω
E15-8 (IND) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND) |
for 2AZ-FE, 2GR-FE (LHD):
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
F3-19 (GND1) - Body ground
Always
Below 1 Ω
for 2GR-FE (RHD):
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
F3-11 (GND1) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT TRANSPONDER KEY ECU ASSEMBLY |
Reconnect the E15 ECU and F3 clock connectors.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E15-8 (IND) - Body ground
Immobiliser set state
(No key is in ignition key cylinder)
Repeats 10 to 14 V and below 1 V
|
|
||||
| OK | ||
| ||
