2006-2011 Camry Aurion · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator.

WIRING DIAGRAM

B128327E03

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER

  1. B139188E02
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Perform the ACTIVE TEST according to the display on the tester.

    IMMOBILISER: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indic
    Turn security indicator
    ON/OFF
    -

    OK:
    The security indicator turns on and off according to the tester operation.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT)

  1. Disconnect the E15 ECU and F3 combination meter connectors.B150911E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-8 (IND) - F3-8 (LP)
    Always
    Below 1 Ω
    E15-8 (IND) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)

  1. for 2AZ-FE, 2GR-FE (LHD):

    1. E128063E12
      Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      F3-19 (GND1) - Body ground
      Always
      Below 1 Ω

  1. for 2GR-FE (RHD):

    1. E134476E04
      Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      F3-11 (GND1) - Body ground
      Always
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT TRANSPONDER KEY ECU ASSEMBLY

  1. B128338E03
    Reconnect the E15 ECU and F3 clock connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E15-8 (IND) - Body ground
    Immobiliser set state
    (No key is in ignition key cylinder)
    Repeats 10 to 14 V and below 1 V

    Result:
    Result
    Proceed to
    NG
    A
    OK (for 2GR-FE RHD)
    B
    OK (except 2GR-FE RHD)
    C



B
REPLACE CLOCK ASSEMBLY (Click here)

C
REPLACE CLOCK ASSEMBLY (Click here)
A

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← Security Indicator Light Circuit (Oct 2006 – May 2009)Door Courtesy Switch Circuit (Jun 2006 – Sep 2006) →