2006-2011 Camry Aurion · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This DTC is output when the ECM detects errors in communication with the transponder key ECU and in the communication lines.
This DTC is also output when an engine start is attempted while the ECU communication ID between the transponder key ECU and the ECM is different.
Before troubleshooting for this DTC, make sure that there is no DTC detected in the transponder key ECU. If there is any key code related DTC detected in the transponder key ECU, repair it first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
  1. Errors in communication between ECM and transponder key ECU assembly, and in communication line
  2. Communication ID is different during communication with transponder key ECU
  1. Wire harness
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM

B128330E08

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
  1. If the ECM is replaced, register the ECU communication ID.


1. RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID between the transponder key ECU assembly and ECM.

  1. Check that the engine starts.

    OK:
    The engine starts.



OK
END
NG


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)

  1. Disconnect the E15 ECU and A24*1 or A55*2 ECM connectors.

    HINT:
    *1: for 2AZ-FE, 2GR-FE (RHD)
    *2: for 2GR-FE (LHD)

    B150850E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for 2AZ-FE, 2GR-FE (RHD):
    Tester Connection
    Condition
    Specified Condition
    E15-12 (EFII) - A24-10 (IMO)
    Always
    Below 1 Ω
    E15-13 (EFIO) - A24-11 (IMI)
    E15-12 (EFII) - Body ground
    10 kΩ or higher
    E15-13 (EFIO) - Body ground
    for 2GR-FE (LHD):
    Tester Connection
    Condition
    Specified Condition
    E15-12 (EFII) - A55-10 (IMO)
    Always
    Below 1 Ω
    E15-13 (EFIO) - A55-11 (IMI)
    E15-12 (EFII) - Body ground
    10 kΩ or higher
    E15-13 (EFIO) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE ECM
  1. Replace the ECM (Click herefor 2AZ-FE) (Click here for 2GR-FE).


NEXT


4. REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID between the transponder key ECU assembly and ECM.

  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END


← B2799 Engine Immobiliser System Malfunction (Oct 2006 – May 2009)Security Indicator Light Circuit (Jun 2006 – Sep 2006) →