2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2006


1. REMOVE DRAIN PLUG
  1. Remove the drain plug.

  1. Remove the O-ring.


2. REMOVE RADIATOR TANK UPPER

  1. A104619E03
    Install the claw to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
    SST
    09230-01010   (09231-01010, 09231-01030)

  1. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.

    Dimension B:
    0.2 to 0.3 mm (0.008 to 0.012 in.)

    NOTICE:
    If the stopper bolt is not adjusted, the claw may be damaged.

  1. A128137E02
    Using SST to release the caulking, grip the handle until stopped by the stopper bolt.
    SST
    09230-01010   (09231-01010, 09231-01030)

  1. A128138E01
    Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a soft-faced hammer and remove the tank.

  1. Remove the O-ring.


3. REMOVE RADIATOR TANK LOWER

HINT:
Removal procedure of the radiator tank lower is the same as that of the radiator tank upper.


4. REMOVE OIL COOLER ASSEMBLY

  1. A128140E04
    Remove the bolt and cooler pipe (A).

  1. Remove the nut and plate washer (B).

  1. Remove the oil cooler (C).

  1. Remove the 2 O-rings from the oil cooler (D).

← REMOVAL (from Jun 2009)INSPECTION (from Oct 2006) →