2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2006


1. DISCHARGE FUEL SYSTEM PRESSURE

HINT:
Click here.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

  1. B134699E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. Remove the seat cushion.


4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

  1. B136575E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.


5. REMOVE REAR FLOOR SERVICE HOLE COVER

  1. A129478
    Remove the rear floor service hole cover.

  1. Disconnect the fuel pump connector.


6. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY

  1. A136246E01
    Remove the tube joint clip, and pull out the fuel pump tube.

    NOTICE:
    1. Check that there is no dirt around the fuel tube joint before this work and clean the dirt away.
    2. It is necessary to prevent mud or dirt from entering the fuel tube joint. If mud or dirt enters the joint, the O-rings may not seal properly.
    3. Do not use any tools in this work.
    4. Do not bend, kink, or twist the nylon tube by force.
    5. After disconnecting, cover the fuel tube joint with a plastic bag.
    6. When the fuel tube joint and fuel suction plate are stuck, pinch the fuel tank tube between fingers, and turn it carefully to release. Disconnect the fuel tank tube.


7. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A129480
    Remove the 8 bolts and set plate.


8. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

  1. A129481
    Pull out the fuel suction tube from the fuel tank.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Be careful that the arm of the sender gauge does not bend.

  1. Remove the gasket from the fuel suction tube.

← COMPONENTS (from Oct 2006)DISASSEMBLY (from Oct 2006) →