2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2006


1. REMOVE NO. 2 FUEL SUCTION SUPPORT

  1. A077832E06
    Using a screwdriver with its tip wrapped with tape, disengage the 5 snap claws from the claw holes, and remove the No. 2 fuel suction support.

    NOTICE:
    Do not damage the fuel suction support.


2. REMOVE FUEL PUMP CUSHION RUBBER

  1. A079492E01
    Remove the fuel pump cushion rubber from the fuel pump.


3. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A129482E02
    Disconnect the fuel sender gauge connector (*1).

  1. Unlock the fuel sender gauge, and slide it to remove (*2).


4. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

  1. A129483E02
    Disconnect the fuel pump connector (*1).

  1. Using a screwdriver with its tip wrapped with tape, disengage the 4 snap claws from the claw holes, and pull out the fuel suction plate.

    NOTICE:
    Do not damage the fuel suction support.


5. REMOVE FUEL PUMP HARNESS

  1. A079495E05
    Disconnect the connector (*1).

  1. Using a screwdriver, pry out the fuel pump harness (*2).


6. REMOVE FUEL PUMP

  1. A079496E01
    Pull out the fuel pump from the fuel filter.


7. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

  1. A133536E01
    Pull out the fuel pressure regulator from the fuel filter.

  1. A133534E02
    Remove the O-ring from the fuel pressure regulator.

← REMOVAL (from Oct 2006)INSPECTION (from Oct 2006) →