2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

LVL Terminal Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

  1. By connecting terminals LVL and CG of the DLC3, the AFS ECU initializes the height control sensor signal.

WIRING DIAGRAM

E193008E01

INSPECTION PROCEDURE


1. INSPECT DLC3 TERMINAL VOLTAGE

  1. E106867E52
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E10-8 (LVL) - Body ground
    Ignition switch ON
    10 to 14 V
    E10-8 (LVL) - Body ground
    Ignition switch off
    Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK HARNESS AND CONNECTOR (DLC3 - AFS ECU AND BODY GROUND)

  1. E133246E03
    Disconnect the A61 AFS ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A61-7 (AFWG) - E10-8 (LVL)
    Always
    Below 1 Ω
    A61-7 (AFWG) - Body ground
    Always
    10 kΩ or higher
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AFS ECU


← LVL Terminal Circuit (Oct 2006 – May 2009)COMPONENTS (Jun 2006 – May 2009) →