2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

LVL Terminal Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

  1. By connecting terminals LVL and CG of the DLC3, the AFS ECU or headlight leveling ECU initializes the height control sensor signal.

WIRING DIAGRAM

E116049E03

INSPECTION PROCEDURE


1. INSPECT DLC3 TERMINAL VOLTAGE

  1. E106867E34
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E10-8 (LVL) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    E10-8 (LVL) - Body ground
    Ignition switch off
    Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK VEHICLE CONDITION

Result:
Condition
Proceed to
without AFS
A
with AFS
B



B
Go to step 4
A


3. CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU AND BODY GROUND)

  1. E121449E04
    Disconnect the A20 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-5 (SPDL) - E10-8 (LVL)
    Always
    Below 1 Ω
    A20-5 (SPDL) - Body ground
    Always
    10 kΩ or higher
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

4. CHECK HARNESS AND CONNECTOR (DLC3 - AFS ECU AND BODY GROUND)

  1. E133246E03
    Disconnect the A61 AFS ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A61-7 (AFWG) - E10-8 (LVL)
    Always
    Below 1 Ω
    A61-7 (AFWG) - Body ground
    Always
    10 kΩ or higher
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AFS ECU


← Speed Signal Circuit (Oct 2006 – May 2009)LVL Terminal Circuit (from Jun 2009) →