2006-2011 Camry Aurion · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

*: Use the intelligent tester.

1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.

    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTCs (Click here).

      HINT:
      The skid control ECU is connected to the CAN communication system.
      Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.


      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    4.CHECK DTC AND FREEZE FRAME DATA*
    1. Check for DTCs and Freeze Frame Data (Click here for DTC Check / Clear, Click here for Freeze Frame Data).

      1. Record the DTCs and Freeze Frame Data.

    2. Clear the DTCs.

    3. Recheck for DTCs.

      1. Reproduce the malfunction and check if the DTCs are output again.

        Result:
        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C


    B.

    C.
    A

    5.DIAGNOSTIC TROUBLE CODE CHART
    1. Go to "DIAGNOSTIC TROUBLE CODE CHART" (Click here).

    NEXT

    6.CIRCUIT INSPECTION*
      NEXT

      7.REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          9.SYMPTOM SIMULATION
            NEXT

            10.PROBLEM SYMPTOMS TABLE
            1. Go to "PROBLEM SYMPTOMS TABLE" (Click here).

            NEXT

            11.CIRCUIT INSPECTION*
              NEXT

              12.REPAIR OR REPLACE
                NEXT

                13.CONFIRMATION TEST
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2006 – May 2009)TEST MODE PROCEDURE (Jun 2006 – Sep 2006) →