2006-2011 Camry Aurion · Service Manual ENGINE

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

This DTC is output when a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU, a short in the IG output circuit inside the main body ECU, a short between the main body ECU and relay, and a short in the relay is detected.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2271
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is open or shorted
  1. AM2 fuse
  2. Main body ECU
  3. Wire harness or connector

WIRING DIAGRAM

B157537E01

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS

2. INSPECT FUSE (AM2)
  1. Remove the AM2 fuse from the engine room J/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY)

  1. B138000E13
    Disconnect the E6 and E7 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E7-6 (AM1) - Body ground
    Always
    11 to 14 V
    E6-1 (AM2) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← ON-VEHICLE INSPECTION (from Oct 2006)B2272 Ignition 1 Monitor Malfunction (Oct 2006 – May 2009) →