B2271 Ignition Hold Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
DESCRIPTION
This DTC is output when a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU (instrument panel junction block assembly), a short in the IG output circuit inside the main body ECU (instrument panel junction block assembly), a short between the main body ECU (instrument panel junction block assembly) and relay, and a short in the relay is detected.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2271 |
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU (instrument panel junction block assembly) is open or shorted |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.
| 1. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
- HINT:
- After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).
Check for DTCs again.
- OK:
- DTC is not output.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - BATTERY) |
Disconnect the E6 and E7 ECU connectors.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E7-6 (AM1) - Body ground
Always
11 to 14 V
E6-1 (AM2) - Body ground
Always
11 to 14 V
|
|
||||
| OK | ||
| ||
