DIAGNOSTIC TROUBLE CODE CHART
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC Code" in the DTC chart.
- Inspect the fuse and relay before investigating the trouble areas as shown in the table below.
| DTC Code |
Detection Item |
Trouble Area |
See page |
| C0200/31(*1) |
Right Front Wheel Speed Sensor Signal Malfunction |
1. Front speed sensor RH 2. Front speed sensor circuit RH 3. Front speed sensor rotor RH 4. Sensor installation 5. Brake actuator assembly (skid control ECU) |
Click here
|
| C0205/32(*1) |
Left Front Wheel Speed Sensor Signal Malfunction |
1. Front speed sensor LH 2. Front speed sensor circuit LH 3. Front speed sensor rotor LH 4. Sensor installation 5. Brake actuator assembly (skid control ECU) |
Click here
|
| C0210/33(*1) |
Right Rear Wheel Speed Sensor Signal Malfunction |
1. Rear speed sensor RH 2. Rear speed sensor circuit RH 3. Rear speed sensor rotor RH 4. Sensor installation 5. Brake actuator assembly (skid control ECU) |
Click here
|
| C0215/34(*1) |
Left Rear Wheel Speed Sensor Signal Malfunction |
1. Rear speed sensor LH 2. Rear speed sensor circuit LH 3. Rear speed sensor rotor LH 4. Sensor installation 5. Brake actuator assembly (skid control ECU) |
Click here
|
| C0226/21 |
SFR Solenoid Circuit |
1. SFRR or SFRH solenoid circuit 2. Brake actuator assembly |
Click here
|
| C0236/22 |
SFL Solenoid Circuit |
1. SFLR or SFLH solenoid circuit 2. Brake actuator assembly |
Click here
|
| C0246/23 |
SRR Solenoid Circuit |
1. SRRR or SRRH solenoid circuit 2. Brake actuator assembly |
Click here
|
| C0256/24 |
SRL Solenoid Circuit |
1. SRLR or SRLH solenoid circuit 2. Brake actuator assembly |
Click here
|
| C0273/13(*1) |
Open or Short Circuit in ABS Motor Relay Circuit |
1. ABS No. 1 fuse (Fusible link) 2. Brake actuator assembly (motor relay) 3. Motor relay circuit |
Click here
|
| C0278/11 |
Open or Short Circuit in ABS Solenoid Relay Circuit |
1. ABS No. 2 fuse (Fusible link) 2. Brake actuator assembly (solenoid relay) 3. Solenoid relay circuit |
Click here
|
| C1225/25 |
SMC Solenoid Circuit |
1. Brake actuator assembly (skid control ECU) 2. SMC1 circuit |
Click here
|
| C1226/26 |
SMC Solenoid Circuit |
1. Brake actuator assembly (skid control ECU) 2. SMC2 circuit |
Click here
|
| C1227/27 |
SRC Solenoid Circuit |
1. Brake actuator assembly (skid control ECU) 2. SRC1 circuit |
Click here
|
| C1228/28 |
SRC Solenoid Circuit |
1. Brake actuator assembly (skid control ECU) 2. SRC2 circuit |
Click here
|
| C1237/37 |
Tires of Different Size |
1. Brake actuator assembly (skid control ECU) 2. Speed sensor 3. Speed sensor rotor (front) 4. Rear axle hub and bearing assembly 5. Speed sensor circuit 6. Tire and wheel size 7. Tire deformation |
Click here
|
| C1241/41 |
Low Battery Positive Voltage or Abnormally High Battery Positive Voltage |
1. Battery 2. ECU-IG No. 2 fuse 3. Charging system 4. Power source circuit 5. Brake actuator assembly (internal power source circuit) |
Click here
|
| C1246/46(*2) |
Master Cylinder Pressure Sensor Malfunction |
1. Master cylinder pressure sensor 2. Master cylinder pressure sensor circuit 3. Stop light switch circuit 4. Brake actuator assembly (skid control ECU) |
Click here
|
| C1249/49 |
Open in Stop Light Switch Circuit |
1. Stop light switch 2. Stop light switch circuit 3. Brake actuator assembly (skid control ECU) |
Click here
|
| C1271/71 |
Low Output Signal of Front Speed Sensor RH (Test Mode DTC) |
1. Front speed sensor RH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1272/72 |
Low Output Signal of Front Speed Sensor LH (Test Mode DTC) |
1. Front speed sensor LH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1273/73 |
Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) |
1. Rear speed sensor RH 2. Sensor installation 3. Speed sensor rotor |
Click here
|
| C1274/74 |
Low Output Signal of Rear Speed Sensor LH (Test Mode DTC) |
1. Rear speed sensor LH 2. Sensor installation 3. Speed sensor rotor |
Click here
|
| C1275/75 |
Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) |
1. Front speed sensor RH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1276/76 |
Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC) |
1. Front speed sensor LH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1277/77 |
Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) |
1. Rear speed sensor RH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1278/78 |
Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) |
1. Rear speed sensor LH 2. Sensor installation 3. Sensor rotor |
Click here
|
| C1288/88 |
ECU Version Miss Match |
ECM |
Click here
|
| C1300/62 |
Skid Control ECU Malfunction |
Brake actuator assembly (skid control ECU) |
Click here
|
| C1330/35 |
Right Front Speed Sensor Circuit |
1. Front speed sensor RH 2. Front speed sensor circuit RH 3. Sensor installation |
Click here
|
| C1331/36 |
Left Front Speed Sensor Circuit |
1. Front speed sensor LH 2. Front speed sensor circuit LH 3. Sensor installation |
Click here
|
| C1332/38 |
Right Rear Speed Sensor Circuit |
1. Rear speed sensor RH 2. Rear speed sensor circuit RH 3. Sensor installation |
Click here
|
| C1333/39 |
Left Rear Speed Sensor Circuit |
1. Rear speed sensor LH 2. Rear speed sensor circuit LH 3. Sensor installation |
Click here
|
| U0073/94 |
Control Module Communication Bus OFF |
CAN communication system |
Click here
|
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
- (*1):
- Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
- Clear the DTC.
- (*2):
- Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
- Drive the vehicle at the vehicle speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
- Repeat the above operation 3 times or more and check that the ABS warning light goes off.
- Clear the DTC.
- HINT:
- In some cases, the intelligent tester cannot be used when the ABS warning light remains on.
| DTC Code |
Detection Item |
Trouble Area |
See page |
| 43 |
ABS Control System Malfunction |
ABS control system |
Click here
|
| C0365/28 |
Malfunction in Deceleration Sensor |
1. Yaw rate and acceleration sensor 2. Yaw rate and acceleration sensor circuit 3. Sensor installation 4. Brake actuator assembly (skid control ECU) |
Click here
|
| C1201/51 |
Engine Control System Malfunction |
Engine control system |
Click here
|
| C1231/31 |
Steering Angle Sensor Circuit Malfunction |
1. Steering angle sensor 2. Steering angle sensor circuit 3. Steering angle sensor power supply |
Click here
|
| C1234/34 |
Yaw Rate Sensor Malfunction |
1. Yaw rate and acceleration sensor 2. Yaw rate and acceleration sensor circuit |
Click here
|
| U0100/65 |
Lost Communication with ECM / PCM |
CAN communication system (skid control ECU to ECM) |
Click here
|
| U0123/62 |
Lost Communication with Yaw Rate Sensor Module |
CAN communication system (skid control ECU to yaw rate and acceleration sensor) |
Click here
|
| U0126/63 |
Lost Communication with Steering Angle Sensor Module |
CAN communication system (skid control ECU to steering angle sensor) |
Click here
|