2006-2011 Camry Aurion · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE:)

  1. DTC check

    1. G022986E01
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Observe the blinking pattern of the ABS warning and SLIP indicator lights in order to identify the DTC.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit and the ABS warning and SLIP indicator light circuit.

      Trouble Area
      See procedure
      ABS warning light (Remains on)
      Click here
      ABS warning light (Does not come on)
      Click here
      SLIP indicator light (Remains on)
      Click here
      SLIP indicator light (Does not come on)
      Click here
      TC and CG terminal circuit
      Click here

    4. Count the number of blinks of the ABS warning and slip indicator lights.

      HINT:
      1. How read DTCs:
        Diagnostic trouble codes are represented by the number of blinks of a warning light. For example, code 21 would be shown by 2 blinks, a pause of 1.5 seconds, and then 1 blink.
      2. If one code is detected:
        The light repeats the same code after a pause of 4 seconds.
      3. If multiple code are detected:
        The light outputs one code after another with a 2.5-second pause between each code.
        When all codes have been output, there is a 4-second pause and then the light begins to output the codes again.
      4. The ABS warning and slip indicator lights do not indicate a normal system code.

    5. Codes are explained in the code table (Click here).

    6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

  2. DTC clear

    1. G022986E01
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. BR03890
      Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the warning light indicates a normal system code.

    5. Remove the SST.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.


DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)
  1. DTC check

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Read the DTCs by following the prompts on the tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Operate the intelligent tester to clear the codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch on (IG).

  2. Check that the ABS warning and SLIP indicator lights go off within approximately 3 seconds.

← DTC CHECK / CLEAR (Oct 2006 – May 2009)FREEZE FRAME DATA (Jun 2006 – Sep 2006) →