DTC CHECK / CLEAR
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE:) |
DTC check
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Observe the blinking pattern of the ABS and VSC (without multi information display) warning lights or read the multi information display (with multi information display) in order to identify the DTC.


- HINT:
- If no code appears, inspect the TC and CG terminal circuit, the ABS warning light circuit, and the VSC warning light circuit.
Trouble Area
See procedure
ABS warning light (Remains on)
Click here
ABS warning light (Does not come on)
Click here
VSC warning light (Remains on)
Click here
VSC warning light (Does not come on)
Click here
TC and CG terminal circuit
Click here
- As an example, the blinking patterns for a normal system code and trouble codes 11 and 21 are shown in the illustration.
Codes are explained in the code table (Click here).
After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
DTC clear
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the warning light indicates a normal system code.
Remove the SST.
- HINT:
- Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.
| DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:) |
DTC check
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Read the DTCs by following the prompts on the tester screen.
DTC clear
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Operate the intelligent tester to clear the codes.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch on (IG).
Check that the ABS warning light goes off within approximately 3 seconds.