2006-2011 Camry Aurion · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE LUGGAGE COMPARTMENT DOOR COVER

  1. B135465
    Using a clip remover, remove the 13 clips and luggage compartment door cover.


2. REMOVE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

  1. B136491
    Disconnect the rod.

  1. B136493
    Disconnect the connector.

  1. Remove the 2 bolts and luggage compartment door lock assembly.


3. REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY

  1. B136496
    Disconnect the cable and connector.

  1. B136497
    Remove the 2 nuts and the luggage compartment door lock cylinder assembly.


4. REMOVE REAR SPOILER (w/ Rear Spoiler)

HINT:
When removing the rear spoiler, heat the vehicle body and rear spoiler using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Spoiler
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and spoiler excessively.

  1. B137019E01
    Put protective tape around the rear spoiler.

  1. B137014
    Remove the 2 nuts.

  1. B137015E02
    Insert a piano wire between the vehicle body and rear spoiler.

  1. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the spoiler to the vehicle body.

    B137016E01

    NOTICE:
    1. If reusing the spoiler, take care not to damage the spoiler.
    2. Be careful not to damage the vehicle body.

  1. Disengage the 4 clips and remove the rear spoiler.


5. REMOVE LUGGAGE COMPARTMENT OUTSIDE DOOR GARNISH SUB-ASSEMBLY

  1. B135459E01
    Put protective tape around the luggage compartment door outside garnish sub-assembly.

  1. B135460
    Remove the 3 nuts.

  1. B135461
    Using a moulding remover, disengage the 2 clips and remove the luggage compartment door outside garnish sub-assembly.


6. REMOVE REAR LIGHT ASSEMBLY LH

  1. E128231E01
    Disconnect the connector and clamp.

  1. E128227E01
    Remove the 3 nuts.

  1. Disengage the clip and remove the rear light assembly.


7. REMOVE REAR LIGHT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.


8. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH

  1. E136250E01
    Disconnect the connector.

  1. Disengage the 2 claws and remove the license plate light assembly as shown in the illustration.


9. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.

← ON-VEHICLE INSPECTION (from Jun 2006)DISASSEMBLY (from Jun 2009) →