Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
DESCRIPTION
If the certification ECU detects that the luggage compartment door opener outer switch is pressed when the driver is carrying the electrical key or when the electrical key is left in the luggage compartment door, the certification ECU sends a luggage compartment door open motor drive request signal to the main body ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - LUGGAGE COMPARTMENT OPEN SWITCH)
Disconnect the E58 ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
E58-7 (TSW5) - Body ground
Luggage compartment door opener switch not pushed
10 kΩ or higher
Luggage compartment door opener switch pushed
Below 1 Ω
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)