DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Jun 2006
| DESCRIPTION |
The diagnostic system allows for reading of the trouble codes from the DLC3.
Use the intelligent tester to check and solve the problem.
| CHECK DLC3 |
The main body ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15765-3 and matches the ISO 15765-4 format.

Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
CAN bus line
Ignition switch OFF*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Ignition switch OFF*
200 Ω or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch OFF*
200 Ω or higher
CANH (6) - BAT (16)
HIGH-level CAN bus line
Ignition switch OFF*
6 kΩ or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Ignition switch OFF*
6 kΩ or higher
- NOTICE:
- *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.
Connect the cable of the intelligent tester to the DLC3, turn the ignition switch on and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle or in the tester.
- If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.
- If communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult the Service Department listed in the tool's instruction manual.
- If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.