2006-2011 Camry Aurion · Service Manual SECURITIES

DATA LIST / ACTIVE TEST

System information · Vehicles built from Oct 2006


DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Enter the following menus: Body / Main Body or Entry&Start / Data List.

  4. Read the Data List according to the display on the tester.

    Main Body (Main body ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Engine switch signal / ON or OFF
    ON: Engine switch is on (ACC)
    OFF: Engine switch is off
    -
    IG SW
    Engine switch signal / ON or OFF
    ON: Engine switch is on (IG)
    OFF: Engine switch is off
    -
    D Door Courtesy SW
    D door courtesy switch / ON or OFF
    ON: Driver side door is OPEN
    OFF: Driver side door is CLOSED
    -
    P Door Courtesy SW
    P door courtesy switch / ON or OFF
    ON: Front passenger side door is OPEN
    OFF: Front passenger side door is CLOSED
    -
    RR Door Courtesy SW
    Rear right door courtesy switch / ON or OFF
    ON: Rear right door is OPEN
    OFF: Rear right door is CLOSED
    -
    RL Door Courtesy SW
    Rear left door courtesy switch / ON or OFF
    ON: Rear left door is OPEN
    OFF: Rear left door is CLOSED
    -
    D-Door Lock Pos SW
    Driver's door lock position switch / ON or OFF
    ON: Driver's door is UNLOCKED
    OFF: Driver's door is LOCKED
    -
    P-Door Lock Pos SW
    Passenger door lock position switch / ON or OFF
    ON: Passenger door is UNLOCKED
    OFF: Passenger door is LOCKED
    -
    RR-Door Lock Pos SW
    Rear right door lock position switch / ON or OFF
    ON: Rear right door is UNLOCKED
    OFF: Rear right door is LOCKED
    -
    RL-Door Lock Pos SW
    Rear left door lock position switch / ON or OFF
    ON: Rear left door is UNLOCKED
    OFF: Rear left door is LOCKED
    -
    Luggage Courtesy SW
    Luggage compartment door courtesy switch / ON or OFF
    ON: Luggage compartment door is OPEN
    OFF: Luggage compartment door is CLOSED
    -


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Enter the following menus: Body / Main Body or Entry&Start / Active Test.

  4. Perform the Active Test according to the display on the tester.

    Main Body (Main body ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Hazard warning light
    ON/OFF
    -
    Vehicle Horn
    Vehicle horn
    ON/OFF
    -
    Entry&Start (Certification ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON/OFF
    -
    Security Horn
    Security horn
    ON/OFF
    -

← DIAGNOSIS SYSTEM (from Oct 2006)Engine Hood Courtesy Switch Circuit (from Oct 2006) →