Engine Hood Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT ENGINE HOOD COURTESY SWITCH |
Remove the courtesy switch from the hood lock.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Position
Specified Condition
1 - 2
Free (ON)
Below 1 Ω
Pushed (OFF)
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND) |
Disconnect the A5 switch connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
A5-1 - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE HOOD COURTESY SWITCH) |
Disconnect the E59 ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
(Symbol) Tester Connection
Specified Condition
HSW (E59-24) - (A5-2)
Below 1 Ω
HSW (E59-24) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
