Security Horn Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
When the theft deterrent system is changed from the armed state to the alarm sounding state, the main body ECU can control the security horn.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester main switch on.
Select the item below in the Active Test and then check that the horn sounds.
Main Body (Main Body ECU): Item
Test Details
Diagnostic Note
Security Horn
Security horn ON/OFF
-
- OK:
- The security horn sounds or stops correctly when operating it through the intelligent tester.
|
|
||||
| OK | ||
| ||
| 2. INSPECT SECURITY HORN ASSEMBLY |
Remove the security horn assembly.

Check operation of the horn.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Horn sounds
Battery negative (-) → Horn body
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - SECURITY HORN ASSEMBLY) |
Disconnect the 1A J/B connector and the A23 horn connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Terminal Connection
Specified Condition
1A-5 - A23-1
Below 1 Ω
1A-5 - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE ROOM J/B) |
Disconnect the E9 ECU connector and 1D J/B connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Symbol (Terminal Connection)
Specified Condition
SH (E9-6) - (1D-11)
Below 1 Ω
SH (E9-6) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - BATTERY) |
Disconnect the 1G J/B connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Terminal Connection
Specified Condition
1G-1 - Body ground
10 to 14 V
|
|
||||
| OK | ||
| ||
