2006-2011 Camry Aurion · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

Even when the theft deterrent system is in the disarmed state, the security indicator blinks due to a signal output from the immobiliser system. The security indicator blinks continuously due to a continuous signal received from the immobiliser system while in the armed state.
The main body ECU causes the security indicator to come on or blink only during the arming preparation state and alarm sounding states.

WIRING DIAGRAM

B139445E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Press the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the indicator operates.

    Main Body (Main body ECU): 
    Tester Display
    Test Details
    Diagnostic Note
    Security Indicator
    Security Indicator ON/OFF
    -

    OK:
    The security indicator light flashes or goes off correctly when operating it through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - MAIN BODY ECU)

  1. B139459E01
    Disconnect the E9 ECU connector.

  1. Disconnect the F3 clock connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    IND (E9-4) - LP (F3-8)
    Below 1 Ω
    IND (E9-4) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BODY GROUND)

  1. B150393E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    GND1 (F3-19) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT CLOCK ASSEMBLY

  1. B150387E01
    Reconnect the F3 clock connector.

  1. Apply battery voltage between the terminals of the indicator, and check the lighting condition of the security indicator.

    Standard :
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal F3-8 (LP)
    Battery negative (-) → Terminal F3-19 (GND1)
    Security indicator comes on

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
    2. Voltage of more than 12 V will damage the security indicator.
    3. If the voltage is too low, the security indicator will not come on.



NG
REPLACE CLOCK ASSEMBLY
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


← Ignition Switch Circuit (from Jun 2006)Security Indicator Light Circuit (from Oct 2006) →