2006-2011 Camry Aurion · Service Manual BRAKE

C1225/25 SMC Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Jun 2009

Also covers:

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

These solenoids turn on when signals are received from the skid control ECU and they control the pressure acting on the wheel cylinders to control the braking force.
DTC No.
DTC Detecting Condition
Trouble Area
C1225/25
Solenoid valve signal does not match the check result
  1. Brake actuator assembly (skid control ECU)
  2. SMC1 circuit
C1226/26
Solenoid valve signal does not match the check result
  1. Brake actuator assembly (skid control ECU)
  2. SMC2 circuit
C1227/27
Solenoid valve signal does not match the check result
  1. Brake actuator assembly (skid control ECU)
  2. SRC1 circuit
C1228/28
Solenoid valve signal does not match the check result
  1. Brake actuator assembly (skid control ECU)
  2. SRC2 circuit

WIRING DIAGRAM

C144435E08

INSPECTION PROCEDURE


1. RECONFIRM DTC

HINT:
These codes are detected when a problem is identified in the brake actuator assembly.
The solenoid circuits are located in the brake actuator assembly.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B

    HINT:
    1. If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly (skid control ECU). Make sure that no DTCs are output.
    2. If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.
    3. It is suspected that the DTCs were output due to a bad connection of the connector terminal.



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

END


← C1225/25 SMC Solenoid Circuit (+ C1226/26, C1227/27, C1228/28) (Oct 2006 – May 2009)C1231/31 Steering Angle Sensor Circuit Malfunction (Jun 2006 – Sep 2006) →