2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

DISASSEMBLY

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE NO. 2 HEADLIGHT BACK COVER (w/o AFS)

  1. E134274
    Remove the No. 2 headlight back cover as shown in the illustration.


2. REMOVE NO. 1 HEADLIGHT BACK COVER (for HID Headlight without AFS)

  1. E134783
    Remove the No. 1 headlight back cover as shown in the illustration.

    HINT:
    Turn the cover in the direction indicated by the arrow in the illustration to release the lock. Turn the cover back to its original position. Pull out the cover slightly downward at an angle to remove it. (Only for the LH side)


3. REMOVE NO. 1 HEADLIGHT BACK COVER (for HID Headlight with AFS)

  1. E134227
    Loosen the 4 screws and remove the No. 1 headlight back cover.

    HINT:
    The screws cannot be removed from the cover.


4. REMOVE NO. 1 HEADLIGHT BULB (w/o AFS)
  1. Disconnect the connector.

  1. E134781
    Remove the No. 1 headlight bulb as shown in the illustration.


5. REMOVE NO. 1 HEADLIGHT BULB (for HID Headlight with AFS)
  1. Disconnect the connector.

  1. E134228
    Remove the No. 1 headlight bulb as shown in the illustration.


6. REMOVE NO. 2 HEADLIGHT BULB (for Halogen Headlight)

  1. E134994
    Remove the No. 2 headlight bulb as shown in the illustration.


7. REMOVE DISCHARGE HEADLIGHT BULB (for HID Headlight without AFS)

  1. E134785
    Separate the light control ECU socket as shown in the illustration.

  1. E134787E01
    Release the set spring and remove the discharge headlight bulb as shown in the illustration.


8. REMOVE DISCHARGE HEADLIGHT BULB (for HID Headlight with AFS)

  1. E134230
    Separate the light control ECU socket as shown in the illustration.

  1. E134232E01
    Release the set spring and remove the discharge headlight bulb as shown in the illustration.


9. REMOVE FRONT TURN SIGNAL LIGHT BULB

  1. E134234
    Turn the front turn signal light bulb and the front turn signal light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the front turn signal light bulb from the front turn signal light socket.


10. REMOVE CLEARANCE LIGHT BULB

  1. E134236
    Turn the front side marker light bulb and the front side marker light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the front side marker light bulb from the front side marker light socket.


11. REMOVE LIGHT CONTROL ECU SUB-ASSEMBLY (for HID Headlight)

  1. E134240
    Remove the 4 screws.

  1. E134241
    Disconnect the connector and remove the light control ECU sub-assembly.


12. REMOVE HEADLIGHT GASKET (for HID Headlight)
  1. Remove the headlight gasket.

    NOTICE:
    After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

← REMOVAL (from Jun 2009)DISASSEMBLY (from Jun 2009) →