2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Oct 2006


CHECK WINDSHIELD WIPER RELAY ASSEMBLY (AUTO WIPER RELAY)
E125552E02
  1. Disconnect the E26 relay connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    W (E26-4) - Body ground
    GR - Body ground
    Front washer switch circuit
    Front washer switch is ON
    Below 1 Ω
    Front washer switch is OFF
    10 kΩ or higher
    IG (E26-12) - Body ground
    L - Body ground
    IG signal circuit
    Ignition switch ON
    10 to 14 V
    Ignition switch OFF
    Below 1 V
    WIG (E26-23) - Body ground
    B - Body ground
    WIG signal circuit
    Ignition switch ON
    10 to 14 V
    Ignition switch OFF
    Below 1 V
    E (E26-26) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E26 relay connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    +2S (E26-1) - Body ground
    P - Body ground
    Front wiper LO speed signal circuit
    Ignition switch ON,
    front wiper switch LO
    10 to 14 V
    Ignition switch ON,
    front wiper switch except LO
    Below 1 V
    +1 (E26-2) - Body ground
    R - Body ground
    Front wiper motor LO speed signal circuit
    Front wiper motor is in LO operation
    10 to 14 V
    Front wiper motor is OFF
    Below 1 V
    +2 (E26-3) - Body ground
    V - Body ground
    Front wiper motor HI speed signal circuit
    Front wiper motor is in HI operation
    10 to 14 V
    Front wiper motor is OFF
    Below 1 V
    W (E26-4) - Body ground
    GR - Body ground
    Front washer motor circuit
    Front washer switch is ON
    Below 1 V
    Front washer switch is OFF
    10 to 14 V
    +SM (E26-10) - Body ground
    Y- Body ground
    Front wiper motor operation signal
    Front wiper motor is in LO or HI operation
    10 to 14 V
    Front wiper motor is OFF
    Below 1 V
    C1 (E26-17) - CO (E26-16)
    P - R
    IG signal circuit
    Ignition switch ON
    10 to 14 V
    Ignition switch OFF
    Below 1 V
    If the result is not as specified, the relay may have a malfunction.

← PROBLEM SYMPTOMS TABLE (from Jun 2009)FAIL-SAFE CHART (from Oct 2006) →