2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Headlight Cleaner Switch Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

This circuit detects the conditions of the headlight cleaner switch.

WIRING DIAGRAM

E119092E01

INSPECTION PROCEDURE


1. CHECK HEADLIGHT OPERATION
  1. Check if the headlights operate normally.

    OK:
    The headlights operate normally.



NG
GO TO LIGHTING SYSTEM
OK


2. INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

  1. E125000E01
    Remove the headlight cleaner switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 8
    ON
    Below 25 Ω
    OFF
    10 kΩ or higher



NG
REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (CLEANER SWITCH - INSTRUMENT PANEL J/B, CLEANER RELAY)
E119093E02
  1. Disconnect the E4 headlight cleaner switch assembly connector.

  1. Disconnect the A39 headlight cleaner control relay connector.

  1. Disconnect the IH instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-8 - A39-2 (H)
    Always
    Below 1 Ω
    E4-8 - Body ground
    Always
    10 kΩ or higher
    E4-5 - IH-13
    Always
    Below 1 Ω
    E4-5 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK WIRE HARNESS (CLEANER RELAY - INSTRUMENT PANEL J/B)
E119094E01
  1. Disconnect the ID instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A39-1 (HDLO) - ID-3
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK INSTRUMENT PANEL J/B

  1. E119095E01
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IH-13 - Body ground
    Engine switch on (IG) and headlight dimmer switch OFF
    Below 1 V
    IH-13 - Body ground
    Engine switch on (IG) and headlight dimmer switch ON
    10 to 14 V



NG
REPLACE INSTRUMENT PANEL J/B
OK

REPLACE PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Rain Sensor Circuit (from Oct 2006)Headlight Cleaner Motor and Relay Circuit (from Oct 2006) →