INSTALLATION
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1. INSTALL REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET |
Install the rear support bracket with the 2 bolts.

- Torque:
- 33 N*m{ 337 kgf*cm , 24 ft.*lbf }
- NOTICE:
- Be sure to install the bracket in the correct direction.
| 2. INSTALL HEATED OXYGEN SENSOR |
Temporarily tighten the heated oxygen sensor.
- NOTICE:
- Do not damage the heated oxygen sensor.
Using SST, fully tighten the heated oxygen sensor.

- SST
- 09224-00010
- Torque:
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf }
- NOTICE:
- The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).
Connect the heated oxygen sensor connector.

| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket onto the front exhaust pipe assembly.
Install the front exhaust pipe assembly with the 2 nuts.
- Torque:
- 62 N*m{ 632 kgf*cm , 46 ft.*lbf }


Install the front exhaust pipe No. 1 support bracket with the 2 nuts.
- Torque:
- 33 N*m{ 337 kgf*cm , 24 ft.*lbf }
| 4. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Install a new gasket onto the front exhaust pipe.
Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.


- Torque:
- 56 N*m{ 571 kgf*cm , 41 ft.*lbf }
| 5. INSTALL TAIL PIPE ASSEMBLY |
Install a new gasket onto the center exhaust pipe assembly.
Install the tail pipe assembly with the 2 nuts.


- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
| 6. CHECK FOR EXHAUST GAS LEAKS |
