2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2009


INSPECT STOP LIGHT CONTROL RELAY

  1. E142629E44
    Disconnect the E90 stop light control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E90-2 (STP) - Body ground
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    E90-6 (+B) - Body ground
    Always
    11 to 14 V

    If the result is not as specified, repair or replace the wire harness or connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E90-4 (GND) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, repair or replace the wire harness or connector.

  1. E150985E36
    Reconnect the E90 stop light control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E90-8 (OUT) - Body ground
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V

    If the result is not as specified, replace the stop light control relay.

← REMOVAL (from Jun 2009)INSTALLATION (from Jun 2009) →