2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

B1242 Wireless Door Lock Tuner Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

  1. The electrical key antenna is used to receive electric waves relating to the entry functions of the smart entry and start system. The certification ECU decodes the requested smart entry and start system operation by identifying a key code based on electric waves received via the electrical key antenna and the door control receiver.
  2. The door control receiver receives a signal from the wireless door control transmitter and sends signals to the main body ECU through the certification ECU.
  3. The certification ECU then sends a command, according to the requested operation, to each ECU. (e.g. If door lock operation is requested, the ECU sends a door lock command to the main body ECU.)
DTC No.
DTC Detection Condition
Trouble Area
B1242
The certification ECU detects that there is a short in the circuit between terminals RSSI, or between terminals DATA and RDA.
  1. Door Control Receiver
  2. Wire harness
  3. Certification ECU

WIRING DIAGRAM

B131913E07

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)
B139429E02
  1. Disconnect the E58 certification ECU connector and O18 door control receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    RSSI (E58-39) - RSSI (O18-5)
    Always
    Below 1 Ω
    RDA (E58-38) - DATA (O18-3)
    Always
    Below 1 Ω
    RSSI (E58-39) - RDA (E58-38)
    Always
    10 kΩ or higher
    RSSI (E58-39) - Body ground
    Always
    10 kΩ or higher
    RDA (E58-38) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT CERTIFICATION ECU
B139430E04
  1. Reconnect the E58 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    RSSI (E58-39) - E (E58-17)
    Engine switch off, all doors closed, the electrical key is not in the actuation area
    Below 1 V
    Engine switch off, all doors closed, the electrical key is in the actuation area
    4.6 to 5.4 V
    RDA (E58-38) - E (E58-17)
    Engine switch off, all doors closed and transmitter switch not pressed
    10 to 14 V pulse generation at regular intervals
    Engine switch off, all doors closed and transmitter switch pressed
    Pulse generation



NG
REPLACE CERTIFICATION ECU
OK


3. REPLACE DOOR CONTROL RECEIVER
  1. Replace the door control receiver with a normal one.

  1. Perform the registration procedure.

    OK:
    The system returns to normal operation.



NG
REPLACE CERTIFICATION ECU
OK

END


← DIAGNOSTIC TROUBLE CODE CHART (from Oct 2006)Wireless Door Lock Buzzer Circuit (from Oct 2006) →