2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Wireless Door Lock Buzzer Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The certification ECU activates the wireless door lock buzzer when detecting a lock/unlock signal from the door control transmitter.

WIRING DIAGRAM

B139432E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - WIRELESS DOOR LOCK BUZZER - BODY GROUND)

  1. B139431E01
    Disconnect the E58 certification ECU connector and A48 wireless door lock buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    BZR (E58-21) - A48-1
    Always
    Below 1 Ω
    BZR (E58-21) - Body ground
    Always
    10 kΩ or higher
    A48-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT WIRELESS DOOR LOCK BUZZER

  1. B144393E01
    Measure the resistance according to the value(s) in the table below.

    HINT:
    The buzzer activation circuit is built into the ECU, not into the buzzer itself. When battery voltage is applied directly to the buzzer, the buzzer will not sound.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A48-1 - A48-2
    Always
    Approx. 1 kΩ



NG
REPLACE WIRELESS DOOR LOCK BUZZER
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← B1242 Wireless Door Lock Tuner Circuit Malfunction (from Oct 2006)Power Source Circuit (from Oct 2006) →