Power Source Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
The certification ECU provides power for the door control receiver operation.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT CERTIFICATION ECU (+B TERMINAL) |
Measure the voltage according to value(s) in the table below.

- Standard voltage:
Symbol
(Tester Connection)
Condition
Specified Condition
+B (E58-1) - E (E58-17)
Always
10 to 14 V
|
|
||||
| OK | |
| 2. INSPECT CERTIFICATION ECU (RC0 TERMINAL) |
Measure the voltage according to value(s) in the table below.

- Standard voltage:
Symbol
(Tester Connection)
Condition
Specified Condition
RC0 (E58-29) - E (E58-17)
Engine switch off, all doors closed and transmitter switch not pressed
Below 1 V
Engine switch off, all doors closed and transmitter switch pressed
4.6 to 5.4 V
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER) |
Disconnect the E58 certification ECU connector.

Disconnect the O18 door control receiver connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Symbol
(Tester Connection)
Condition
Specified Condition
RC0 (E58-29) - +5 (O18-2)
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Symbol
(Tester Connection)
Condition
Specified Condition
GND (O18-6) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 5. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY - BODY GROUND) |
Disconnect the E58 certification ECU connector.
Measure the voltage and resistance according to value(s) in the table below.

- Standard:
Symbol
(Tester Connection)
Condition
Specified Condition
RC0 (E58-29) - Body ground
Always
Below 1 V
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
