The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts vehicle position.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT NAVIGATION RECEIVER ASSEMBLY
Disconnect the navigation receiver assembly connector F13.
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester connection
Condition
Specified condition
F13-5 (REV) - Body ground
Ignition switch is ON. Shift lever is moved to R position.
10 to 14 V
F13-5 (REV) - Body ground
Ignition switch is ON. Shift lever is moved to any position except R.
Below 1 V
OK
REPLACE NAVIGATION RECEIVER ASSEMBLY
NG
2. CHECK HARNESS AND CONNECTOR
Disconnect the navigation receiver assembly connector F13 and park/neutral position switch connector C1 or back-up light switch connector C28.
Measure the resistance according to the value(s) in the table below.