2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM

E176572E08

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E168562E08
    Disconnect the F13 navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F13-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever in R
    11 to 14 V
    F13-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever in any position except R
    Below 1 V

    Result:
    Result
    Proceed to
    OK
    A
    NG
    (for 2GR-FE RHD)
    B
    NG
    (except 2GR-FE RHD)
    C

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
A


2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)
  1. Disconnect the F13 navigation receiver assembly connector.

  1. Disconnect the C1 park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F13-5 (REV) - C1-2 (RL)*1
    Always
    Below 1 Ω
    F13-5 (REV) - C1-1 (RL)*2
    Always
    Below 1 Ω
    F13-5 (REV) - Body ground
    Always
    10 kΩ or higher

    1. *1: for 2GR-FE
    2. *2: for 2AZ-FE



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C1-1 (RB) - Body ground*1
    Ignition switch on (IG)
    11 to 14 V
    C1-2 (RB) - Body ground*2
    Ignition switch on (IG)
    11 to 14 V

    1. *1: for 2GR-FE
    2. *2: for 2AZ-FE

    Result:
    Result
    Proceed to
    NG
    A
    OK (for U660E)
    B
    OK (for U250E)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U660E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U250E) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Reverse Signal Circuit (Oct 2006 – May 2009)Microphone Circuit between Microphone and Navigation Receiver Assembly (Jun 2006 – Sep 2006) →