Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.
NOTICE:
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
4.
REMOVE V-RIBBED BELT
Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
SST
09249-63010
While turning the belt tensioner counterclockwise, align with its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.
5.
REMOVE CRANKSHAFT PULLEY
Using SST, loosen the crankshaft pulley bolt.
SST
09213-70011
(09213-70020)
09330-00021
Using SST, remove the crankshaft pulley bolt and crankshaft pulley.