2006-2011 Camry Aurion · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL BRAKE PEDAL PAD
  1. Install the brake pedal pad.


2. INSTALL BRAKE PEDAL SUB-ASSEMBLY
  1. Apply lithium soap base glycol grease to 2 new brake pedal bushings.

  1. C132724E01
    Install the brake pedal sub-assembly, the 2 brake pedal bushings, and the brake pedal shaft collar to the brake pedal support assembly with the bolt and the nut as shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


3. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Install the stop light switch mounting adjuster.


4. TEMPORARILY TIGHTEN STOP LIGHT SWITCH ASSEMBLY

  1. C132726
    Temporarily tighten the stop light switch assembly as shown in the illustration.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    HINT:
    Fully install the stop light switch assembly after adjusting the brake pedal height.

← ADJUSTMENT (from Jun 2006)INSTALLATION (Jun 2006 – Sep 2006) →