The structure of the master cylinder allows the piston to pop out, so observe the following:
The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.
Do not scratch or damage the circumference of the piston. For the seal to function correctly, all sliding surfaces must not have any damage.
Do not pull out the master cylinder piston.
Make sure to release the vacuum from the brake booster (by removing a vacuum hose, etc.) before removing the master cylinder from the brake booster.
When installing the master cylinder, remove the protectors for the piston and the discharge port.
Apply the supplied grease to the outer diameter of the piston and the inner diameter of the brake booster.
1.
DRAIN BRAKE FLUID
NOTICE:
Stop the engine and depress the brake pedal several times until no vacuum is left in the brake booster.
If the brake fluid leaks onto any painted surface, wash off and remove the brake fluid completely.
2.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for LHD)
Disconnect the mass air flow meter connector (*1).
Disconnect the purge VSV connector (*2).
Disconnect the 2 purge VSV vacuum hoses (*3).
Disconnect the purge line hose from the clamp (*4).
Disconnect the No. 2 ventilation hose from the air cleaner hose.
Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.
Remove the 2 bolts and air cleaner cap.
Remove the air cleaner filter element from the air cleaner case.
3.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for LHD)
4.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut and the front wiper arm and blade assembly LH.
5.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut and the front wiper arm and blade assembly RH.
6.
REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Disengage the claw and remove the front fender to cowl side seal LH.
7.
REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Disengage the claw and remove the front fender to cowl side seal RH.
8.
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Remove the 2 clips.
Disengage the 4 claws and remove the cowl top ventilator louver sub-assembly.
9.
REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Disconnect the connector.
Remove the 4 bolts and the windshield wiper motor and link assembly.
10.
REMOVE COWL TOP OUTER FRONT PANEL SUB-ASSEMBLY
Disengage the clamp.
Remove the 4 nuts, the 4 bolts and the cowl top outer front panel sub-assembly.