2006-2011 Camry Aurion · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for RHD)
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.


2. DISCONNECT SUCTION PIPE SUB-ASSEMBLY (for RHD)

  1. E128510
    Remove the bolt, and slide the hook connector.

  1. Disconnect the suction pipe sub-assembly.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


3. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY (for RHD)
  1. Disconnect the air conditioning tube and accessory.

  1. Remove the O-ring from the air conditioner tube and accessory.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


4. DISCONNECT BRAKE LINE (for RHD)
  1. Using SST, disconnect the 6 brake lines from the actuator assembly with bracket.

    1. ABS: Click here

    2. VSC: Click here

  1. C133315E01
    Separate the brake line from the clamp.


5. REMOVE BRAKE PEDAL RETURN SPRING (for LHD)

  1. C133454
    Remove the brake pedal return spring.


6. REMOVE BRAKE PEDAL RETURN SPRING (for RHD)

  1. C132838E01
    Remove the brake pedal return spring.


7. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

  1. C133451E02
    Remove the clip and push rod clevis pin, and separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.


8. DISCONNECT NO. 2 VACUUM HOSE (for LHD)

  1. C132715
    Move the clip and disconnect the No. 2 vacuum hose.


9. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE MASTER CYLINDER". (Click here)


10. DISCONNECT NO. 2 VACUUM HOSE (for RHD)

  1. C132845
    Move the clip and disconnect the No. 2 vacuum hose.


11. REMOVE BRAKE BOOSTER ASSEMBLY

  1. C132719
    Remove the 4 nuts and the brake booster assembly.

    NOTICE:
    Do not damage the brake lines.


12. REMOVE BRAKE BOOSTER GASKET

  1. C132835E02
    Remove the brake booster gasket.

← ON-VEHICLE INSPECTION (from Jun 2006)REMOVAL (Oct 2006 – May 2009) →