REMOVAL
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
 |
- Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.
| 2.
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
 |
- Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.
| 3.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
|
 |
- Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 4.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)
|
 |
- Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 5.
REMOVE UPPER CONSOLE PANEL (for Manual Transaxle)
|
 |
- Open the lid of the upper console panel.
Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the upper console panel as shown in the illustration.
| 6.
REMOVE POSITION INDICATOR HOUSING ASSEMBLY (for Automatic Transaxle)
|
 |
- Open the lid of the upper console panel.
Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the position indicator housing assembly as shown in the illustration.
| 7.
REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
|
 |
- Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.
| 8.
REMOVE CONSOLE BOX POCKET
|
 |
Remove the console box pocket.
| 9.
REMOVE CONSOLE BOX CARPET
|
 |
- Remove the console box carpet.
| 10.
REMOVE CONSOLE BOX ASSEMBLY
|
 |
- Remove the 2 screws <F>.
- Disengage the clamp.
Remove the 2 bolts <G> and the console box assembly.
| 11.
SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
 |
- Loosen the lock nut and the No. 1 wire adjusting nut of the No. 1 parking brake cable assembly.
- Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
| 12.
SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY |
 |
- Separate the No. 2 parking brake cable assembly from the parking brake equalizer.
| 13.
REMOVE PARKING BRAKE EQUALIZER |
 |
- Slide the rubber boot as shown in the illustration.
- Remove the parking brake equalizer from the No. 1 parking brake cable assembly.
| 14.
REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY |
 |
- Disconnect the parking brake switch connector.
Remove the 2 bolts and the parking brake lever sub-assembly.