2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B150434E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150436
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150438
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


2. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B150435E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150437
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150439
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


3. REMOVE LOW PITCHED HORN ASSEMBLY

  1. E127997
    Disconnect the connector.

  1. Remove the bolt and the low pitched horn assembly.

← COMPONENTS (from Oct 2006)REMOVAL (from Jun 2009) →