REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1. REMOVE FRONT BUMPER ASSEMBLY |
Put protective tape around the front bumper assembly.

Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

- HINT:
- Use the same procedure for the RH side and LH side.
Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

- HINT:
- Use the same procedure for the RH side and LH side.
w/o Fog Light:
Remove the front bumper assembly.
w/ Fog Light:
Disconnect each connector, and then remove the front bumper assembly.
| 2. REMOVE LOW PITCHED HORN ASSEMBLY |
Disconnect the connector.

Remove the bolt and the low pitched horn assembly.
