2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B161416
    Remove the 7 clips and cool air intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B160025E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B160026
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B160027
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


3. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B160028E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B160029
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B159433
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


4. REMOVE FRONT BUMPER ASSEMBLY (w/ Clearance Sonar System)

  1. B160028E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B160029
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B159433
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


5. REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System)

  1. B160028E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B160029
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B159433
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. B149621
    Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.


6. REMOVE LOW PITCHED HORN ASSEMBLY

  1. E136739
    Disconnect the connector.

  1. Remove the bolt and the low pitched horn assembly.

← COMPONENTS (from Oct 2006)REMOVAL (from Jun 2009) →