2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B232362
    Remove the 7 clips and cool air intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B232367E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B232368
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B232369
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/ Clearance Sonar System:

    1. Disconnect the 2 connectors.

  1. w/ Fog Light:

    1. Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:

    1. Disconnect the 2 connectors.

    2. B149621
      Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.

  1. Remove the front bumper assembly.


3. REMOVE LOW PITCHED HORN ASSEMBLY

  1. E136739
    Disconnect the connector.

  1. Remove the bolt and the low pitched horn assembly.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Oct 2006) →