ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
When the ignition switch is turned on (IG), voltage from the ECM's MREL terminal is applied to the EFI relay. This causes the contacts of the EFI relay to close, which supplies power to terminal +B of the TCM.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL) |
Disconnect the TCM connector.

Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Specified Condition
+B (C56-18) - Body ground
9 to 14 V
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Specified Condition
E1 (C56-8) - Body ground
Below 1 Ω
Reconnect the TCM connector.
|
|
||||
| OK | ||
| ||
