2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2006


1. INSTALL RAIN SENSOR TAPE

NOTICE:
The rain sensor tape can be reused, however, replace it with a new one if it is dirty or damaged.

HINT:
This step should be performed only when the rain sensor tape needs to be replaced.

  1. E128846E01
    Remove the releasing sheet (yellow side) from new rain sensor tape and attach the tape to the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with your fingers.

  1. Remove the releasing sheet (white side) from the rain sensor tape.

    NOTICE:
    1. Check that the old rain sensor tape is not left on the windshield glass. If the tape is still on the windshield glass, remove it before installing the rain sensor.
    2. Do not touch the sensor tape surface or the glass surface directly with your fingers.
    3. Clean up dirt on the glass with a cloth, etc.

    Area
    Measurement
    A
    7.3 mm (0.287 in.)
    B
    13.5 mm (0.531 in.)


2. INSTALL RAIN SENSOR

  1. E128845
    Connect the connector.

  1. E128847E01
    Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

  1. Hold the rain sensor and push in the stopper.

    NOTICE:
    1. Do not touch the sensor tape surface or the glass surface directly with your fingers.
    2. Clean up dirt on the glass with a cloth, etc.
    3. After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.


3. INSTALL RAIN SENSOR COVER

  1. E128843
    Install the rain sensor cover.

← REMOVAL (from Jun 2006)COMPONENTS (Jun 2006 – Sep 2006) →