1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 7 clips and intake duct seal.
3.
REMOVE V-BANK COVER SUB-ASSEMBLY
Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.
NOTICE:
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
4.
REMOVE AIR CLEANER INLET ASSEMBLY
Remove the 2 bolts, clamp and air cleaner inlet.
5.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the 3 vacuum hoses.
Disconnect the mass air flow meter connector (*1).
Disconnect the No. 2 ventilation hose (*2).
Disconnect the hose band (*3).
Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.
6.
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Disconnect the vacuum hose and hose clamp.
Remove the 3 bolts and air cleaner case.
7.
REMOVE NO. 1 AIR CLEANER INLET
Remove the bolt and No. 1 air cleaner inlet.
8.
REMOVE STARTER ASSEMBLY
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut and disconnect the wire harness from terminal 30.