DATA LIST / ACTIVE TEST
System information · Vehicles built from Oct 2006
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Enter the following menus: Body / MAIN BODY or Entry&Start / Data List.
Read the Data List according to the display on the tester.
MAIN BODY (Main body ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Wireless Control
Wireless door lock control function / ON or OFF
ON: Operating
OFF: Not operating
-
Hazard Answer Back
Hazard answer-back of wireless / ON or OFF
ON: Operating
OFF: Not operating
-
Open Door Warning
Open door warning / ON or OFF
ON: Operating
OFF: Not operating
-
Auto Lock Time
Automatic lock time / 60 s or 30 s
60 s: 60 seconds
30 s: 30 seconds
-
Unlock 2 Operation
2 times operation of wireless unlock / ON or OFF
ON: All doors unlock when UNLOCK switch pressed twice
OFF: All doors unlock when UNLOCK switch pressed once
-
Wireless Buzzer Resp
Wireless door lock buzzer response / ON or OFF
ON: Operating
OFF: Not operating
-
Trunk Lid Operation
Luggage compartment door open function type / 1tim ON/2tim ON/0.8 s/Prohibit
1tim ON: Luggage compartment door opens when LUGGAGE OPEN switch is pressed once
2tim ON: Luggage compartment door opens when LUGGAGE OPEN switch is pressed twice
0.8 s: Luggage compartment door opens when LUGGAGE OPEN switch is pressed and held down for 0.8 seconds
Prohibit: Not operating
-
Entry&Start (Certification ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Panic Alarm Function
Panic function / ON or OFF
ON: Operating
OFF: Not operating
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Enter the following menus: Body / MAIN BODY or Entry&Start / Active Test.
Perform the Active Test according to the display on the tester.
MAIN BODY (Main body ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Hazard
Turns the turn signal flasher relay
ON/OFF
Observe headlight and rear combination light for correct operation
Vehicle Horn
Turns the vehicle horns
ON/OFF
-
Illuminated Entry System
Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed)
ON/OFF
-
Trunk and Back-Door Open
Turns the luggage compartment door opener motor
ON/OFF
Observe luggage compartment door
Entry&Start (Certification ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Wireless Buzzer Operation
Turns the wireless door lock buzzer
ON/OFF
-