Detach the 2 front hooks of the seat cushion from the vehicle body.
NOTICE:
Follow the instructions below carefully as the cushion frame can be deformed easily.
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the step above for the other hook.
Remove the seat cushion.
5.
REMOVE REAR FLOOR SERVICE HOLE COVER
Remove the rear floor service hole cover.
Disconnect the fuel pump connector.
6.
SEPARATE FUEL PUMP TUBE SUB-ASSEMBLY
Remove the tube joint clip, and pull out the fuel pump tube.
NOTICE:
Check that there is no dirt around the fuel tube joint before this work and clean the dirt away.
It is necessary to prevent mud or dirt from entering the fuel tube joint. If mud or dirt enters the joint, the O-rings may not seal properly.
Do not use any tools in this work.
Do not bend, kink, or twist the nylon tube by force.
After disconnecting, cover the fuel tube joint with a plastic bag.
When the fuel tube joint and fuel suction plate are stuck, pinch the fuel tank tube between fingers, and turn it carefully to release. Disconnect the fuel tank tube.
7.
REMOVE FUEL TANK VENT TUBE SET PLATE
Remove the 8 bolts and set plate.
8.
REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
Pull out the fuel suction tube from the fuel tank.
NOTICE:
Do not damage the fuel pump filter.
Be careful that the arm of the sender gauge does not bend.
Remove the gasket from the fuel suction tube.
9.
REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the fuel sender gauge connector (*1).
Unlock the fuel sender gauge, and slide it to remove (*2).