2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

B1276 Power Mirror Control ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU will store this DTC when no signals can be received from the outer mirror control ECU while the CAN MS main bus is normal.
DTC No.
DTC Detection Condition
Trouble Area
B1276
No communication from outer mirror control ECU
  1. Outer mirror control ECU power source circuit
  2. Outer mirror control ECU
  3. Outer mirror control ECU branch wire or connector

WIRING DIAGRAM

C142761E22

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK DTC
  1. Check for DTCs.

    HINT:
    If CAN MS bus communication error DTC B2326 is output, troubleshoot for B2326 and check for malfunctions in the CAN MS main bus circuit (Click here).

    Result:
    Result
    Proceed to
    B2326 is not output
    A
    B2326 is output
    B



B
GO TO DTC CHART
A


2. CHECK CAN MS BUS WIRE (OUTER MIRROR CONTROL ECU)
  1. Turn the engine switch off.

  1. C142226E02
    Disconnect connector E85 from the outer mirror control ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E85-1 (CAN) - E85-21 (CGND)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN MS BUS BRANCH WIRE OR CONNECTOR (OUTER MIRROR CONTROL ECU)
OK


3. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C142227E12
    Disconnect connector E95 from the outer mirror control ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E95-9 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    E95-4 (ACC) - Body ground
    Engine switch on (ACC)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE OUTER MIRROR CONTROL ECU


← B1276 Power Mirror Control ECU Communication Stop (Oct 2006 – May 2009)B1297 Clearance Sonar ECU Communication Stop (Oct 2006 – May 2009) →