2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

B1207 Certification ECU Communication Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU will store this DTC when no signals can be received from the certification ECU while the CAN MS main bus is normal.
DTC No.
DTC Detection Condition
Trouble Area
B1207
No communication from certification ECU
  1. Certification ECU power source circuit
  2. Certification ECU
  3. Certification ECU main wire or connector

WIRING DIAGRAM

C213969E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK DTC
  1. Check for DTCs.

    HINT:
    If CAN MS bus communication error DTC B2326 is output, troubleshoot for B2326 and check for malfunctions in the CAN MS main bus circuit (Click here).

    Result:
    Result
    Proceed to
    B2326 is not output
    A
    B2326 is output
    B



B
GO TO DTC CHART
A


2. CHECK FOR OPEN IN CAN MS BUS MAIN WIRE (CERTIFICATION ECU)
  1. Turn the engine switch off.

  1. C136713E07
    Disconnect connector E58 from the certification ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E58-27 (CANH) - E58-28 (CANL)
    Engine switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN MS BUS MAIN WIRE OR CONNECTOR (CERTIFICATION ECU)
OK


3. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C136713E08
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E58-17 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    E58-18 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V
    E58-1 (+B) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK

REPLACE CERTIFICATION ECU


← B1207 Certification ECU Communication Malfunction (Oct 2006 – May 2009)B1272 Power Seat ECU Communication Stop (Oct 2006 – May 2009) →